6. Endless feeling
Reason: The spring breaks of the two -way buffer valve on the steering device valve block or the adjustment pressure of the two -way buffer valve is lower than the pressure of the steering safety valve. The right severe wear is too much.
Removal method: Replace the spring or adjust its pressure to the specified value, clean and dredge the pipeline, and replace the steer.
7. The loader suddenly did not raise it during the work period, and there was no steering
Reasons for the problem: The pilot pump side tilt key or the pilot pump shaft is damaged, and the bearing at the connection between the torque and the pilot pump is damaged.
Removal method: Replace the pilot pump or axis key with a sales child to replace the bearings.
8. The front axis or rear axis abnormal sound when the loader is rotated, and the noise disappears when straight
Reason: The planetary gears of differentials do not match the side gears. The planetary gears with poor meshing differentials have tooth or damage on the surface. The planetary gear and differentials are stuck in the horizontal axis or poor gap adjustment.
Removal method: Replace the planetary gear or cross -shaft gear, adjust the gap or replace the gear.
9. The driver of the loader is noisy, and it does not disappear when sliding
Reasons: Insufficient lubricating oil in the bridge shell, the meshing gap between the active cone gears and the passive cone gear is too small, and the gap between the differential shell and the cross -axis planetary gear is too large.
Removal method: Add enough lubricating oil according to the standard and adjust the gap to achieve the specified value.
10. During the walking process, there was no driving front bridge and rear bridge
Reasons: Half -axis break.
Removal method: Replace the semi -axis.
If you need to purchase the loader accessories during the use of the loader, please contact us.
Post time: Apr-02-2024